# $Id: gdoi_ks.conf,v 1.1.2.1 2011/12/12 23:49:35 bew Exp $ # $Source: /nfs/cscbz/gdoi/gdoicvs/gdoi/samples/iec90-5/Attic/gdoi_ks.conf,v $ # # A configuration sample for testing GDOI over loopback interfaces. # This is the key server side. # [General] Retransmits= 5 Exchange-max-time= 120 Listen-on= 127.0.0.2 #GDOI-application-client-support= 1 # Incoming phase 1 negotiations are multiplexed on the source IP address [Phase 1] 127.0.0.1= ISAKMP-peer-client # These connections are walked over after config file parsing and told # to the application layer so that it will inform us when traffic wants to # pass over them. This means we can do on-demand keying. [Phase 2] Passive-Connections= Group-1234 [ISAKMP-peer-client] Phase= 1 Transport= udp Local-address= 127.0.0.2 Address= 127.0.0.1 Configuration= Default-main-mode Authentication= mekmitasdigoat [Group-1234] Phase= 2 Configuration= IEC90_5_group_1 ID-type= IEC90_5 OID= 61850_UDP_ADDR_GOOSE Address= 239.192.1.1 # Main mode descriptions [Default-main-mode] DOI= GROUP EXCHANGE_TYPE= ID_PROT Transforms= 3DES-SHA # Main mode transforms [3DES-SHA] ENCRYPTION_ALGORITHM= 3DES_CBC HASH_ALGORITHM= SHA AUTHENTICATION_METHOD= PRE_SHARED GROUP_DESCRIPTION= MODP_1024 Life= LIFE_60_SECS # Lifetimes [LIFE_60_SECS] LIFE_TYPE= SECONDS LIFE_DURATION= 60,30:120 [LIFE_120_SECS] LIFE_TYPE= SECONDS LIFE_DURATION= 120,90:180 # GDOI description # Group mode description [IEC90_5_group_1] DOI= GROUP EXCHANGE_TYPE= PULL_MODE Crypto-protocol= PROTO_IEC90_5 # # No SA-KEK is defined for the loopback sample. # Rekey messages don't always work across the loopbacks. # SA-TEKS= GROUP1-TEK1 # Src-ID and Dst-ID are the addresses/posrts for the UDP packet. [GROUP1-TEK1] Src-ID= Group-tek1-src Dst-ID= Group-tek1-dst [Group-tek1-src] ID-type= IPV4_ADDR Address= 172.19.137.42 Port= 1024 [Group-tek1-dst] ID-type= IPV4_ADDR Address= 239.192.1.1 Port= 1024